Initial Setup

In this step, we will do a clean installation and configuration of the game, which is required for the guide.

If you run into any issues at any point in the guide, feel free to ask for help on our Discord Server in the #bugs-and-support channel.

Making a Clean Install of Fallout 4

Uninstalling the Game

  1. Open Steam and go to your Library
  2. Find Fallout 4 in the list
  3. Right-click on it and select Manage -> Uninstall
  4. Navigate to Steam\steamapps\common\ and, if present, delete the Fallout 4 folder
  5. Navigate to Documents\My Games and delete the Fallout4 folder
  6. Navigate to AppData\Local and delete the Fallout4 folder

Do not install your game in the Program Files folder. Do not install any game in that folder, or have your Steam Library in there. Program Files is a special Windows System folder, and Fallout 4 doesn’t load mods correctly if it is in that folder.

Installing the Game

  1. Open Steam and go to your Library
  2. Find Fallout 4 in the list and select Install
  3. Select Next then wait for the install to finish

Make sure to install the English version of Fallout 4 for maximum immersion. If you do not use the English version, the intro video which is shown when starting a new game might not have audio.


Key Terminology

Now that the game is installed, there are two folders from it that will be referred to in the guide often:

  • Root folder (where the game is installed): Steam\steamapps\common\Fallout 4

  • Data folder (where all of the game’s assets are located): Steam\steamapps\common\Fallout 4\Data

Enabling File Extensions

By default, Windows Explorer will not show file extensions (such as .exe, .dll, or .esp). These extensions are very important when going through the guide, so it is highly recommended to enable file extensions:

  1. Open Windows Explorer
  2. Select the View tab at the top
  3. Check the box next to File name extensions

Generating Fresh .INI Files

  1. Run Fallout4Launcher.exe from the game’s Root folder
    • If you do not know what the game’s Root folder is, read the Key Terminology section above
  2. Click OK to both pop-ups that say Detecting Video Hardware
    • If there aren’t any pop-ups, navigate to Documents\My Games\Fallout4 and delete all the files ending in .INI then retry
  3. Select Options then select the High preset option
    • The high preset is used over the ultra preset because the ultra preset has options that can severely tank FPS without much visual improvement. You can choose a lower preset if you have a lower-end PC, or want to squeeze as much performance out of the game as possible.
  4. Click OK then Exit

Disabling the High Resolution Texture Pack/DLC from Bethesda

When you installed the game again, it might be possible that you accidently installed the High Resolution Texture Pack/DLC from Bethesda. This DLC takes is not very well made. It barely makes the game look better, it decreases performance, it isn’t optimised very well, and it causes several bugs. I don’t recommend to use it, especially as texture mods from mod authors look a lot better. If you accidently installed it, here is are instructions on how to use uninstall it:

  • Go to your Steam Library by clicking “Library” at the top
  • Click on Fallout 4
  • Click on Support to the right of Fallout 4
  • Scroll to the bottom, if you have the season pass or a lot of dlc, click Show all DLC
  • Click on High Resolution Texture Pack
  • Click on “I want to remove this permanently from my game library”
  • !!! Make sure it says High Resolution Texture Pack at the top, or you’ll remove the entire game with no refund !!!
  • Click OK